Author Topic: 3D low with bearings???  (Read 1490 times)

AznnBoyaZ

  • Thanks: 11
3D low with bearings???
« on: July 31, 2010, 06:01:51 pm »
I only have 3 sundia flys and I can only get 2-10 otts in 3d with them please help!
and also can anyone relate to this or is it not possable?

Tipper

  • VotW Contributor
  • Thanks: 44
Re: 3D low with bearings???
« Reply #1 on: July 31, 2010, 06:25:02 pm »
it is possible to do 3d with bearings. yet very hard. Learning 3d with bearings is near impossible.
Error 404 - Siteswap not found

Diabolo Dodson

  • VotW Contributor
  • Thanks: 46
Re: 3D low with bearings???
« Reply #2 on: July 31, 2010, 07:55:26 pm »
3D low with bearings is horrific, you pretty much have to use a sync pattern and a very flat sync pattern which in my opinion looks horrible. Its very hard to hold the pattern i dont think i could get more than 40-50 ott last time i tried and i can usually hold 3 low up to 10 minutes on fixed axle. They just dont react well to left hand lifting which is the most important part of 3D. Get yourself 3 fixed axle diabolos, i beleive you can buy 3 fixed axles of www.diabolomoves.co.uk and just fit them to your current diabolos, thats probably the cheapest way.

AznnBoyaZ

  • Thanks: 11
Re: 3D low with bearings???
« Reply #3 on: July 31, 2010, 08:04:24 pm »
ok thx guys I really didn't want to have to buy the axles but it's the only way...