Author Topic: Help for making Spinabolo Pro/Fly hybrid?  (Read 1605 times)

Will G

  • Thanks: 10
Help for making Spinabolo Pro/Fly hybrid?
« on: December 08, 2011, 06:53:53 pm »
Looking to put fly guts into a spinabolo pro, I hear some drilling is needed, so I was wondering if anyone could give me some details :)

Marko

  • VotW Contributor
  • Thanks: 79
Re: Help for making Spinabolo Pro/Fly hybrid?
« Reply #1 on: December 08, 2011, 10:39:16 pm »
Yea spots for hubs aren't deep enough. So you will need to carve the cups (or sand down hubs, I don't think anyone has tried that yet. I just used a knife and it took me 1hour per cup to get good enough.
«Diabolo, whiter than the whitest!»

Will G

  • Thanks: 10
Re: Help for making Spinabolo Pro/Fly hybrid?
« Reply #2 on: December 08, 2011, 11:49:34 pm »
So just cut out the section of the cup underneath the hub? Thanks :)

Marko

  • VotW Contributor
  • Thanks: 79
Re: Help for making Spinabolo Pro/Fly hybrid?
« Reply #3 on: December 12, 2011, 08:16:19 pm »
Lovely. ;)
«Diabolo, whiter than the whitest!»